3-24 Phaser 3250 Laser Printer Service Manual
Error Messages and Codes
Paper Rolled on the OPC Drum
Paper is caught or rolled up in the OPC Drum.
The Fuser may be hot. Turn the printer power Off and allow at least 5 minutes
for the Fuser to cool before removing the Fuser.
Do not expose the Print Cartridge to light for more than 5 minutes. Cover the
Print Cartridge to avoid damage.
Do not touch the green surface underneath the Print Cartridge.
Applicable Error Message
■ Paper Rolled on the OPC Drum
Initial Actions
■ Ensure that the Fuser is secured to the printer.
■ Cycle printer power.
■ If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map Reference
■ Print Cartridge, PL1.1.20
■ Fuser, PL9.1.0
■ “Map 7 - LVPS, HVPS, Fuser, Developer
Unit CRUM, and Power Switch” on
page 10-15
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1.Check the paper type.
2.Does the paper type meet
specifications?
Replace the
paper with the
correct
specifications.
Go to step 2.
To Next Page
Loading...
