Xerox Phaser 3250 - Common Postscript Problems

4-14 Phaser 3250 Laser Printer Service Manual
General Troubleshooting
Common PostScript Problems
The following errors are PostScript language specific that may occur when
multiple printer languages are being used.
Note
To receive a printed or screen displayed message when PostScript errors
occur, open the Print Options window and click the appropriate selection
next to the PostScript errors section.
Condition Possible Cause Solutions
PostScript file cannot be
printed.
The PostScript driver
may not be installed
correctly.
■ Print a Configuration
page and verify that
the PostScript version
is available for
printing.
■ Install the PostScript
driver.
“Limit Check Error” message
is displayed.
The print job was too
complex.
Change the complexity of
the print job.
A PostScript error page
prints.
Print job may not be
PostScript.
Make sure that the print
job is a PostScript job.
Check to see whether the
software application
expected setup or
PostScript header file to
be sent to the printer.
When printing a document
using a Macintosh with
Acrobat Reader 6.0 or higher,
colors print incorrectly.
The resolution setting in
the printer driver may not
be matched with that in
Acrobat Reader.
Make sure that the
resolution setting in your
printer driver matches
information in Acrobat
Reader.