ELECTRICAL COMPONENTS
8-186
EAS1MC1086
CHECKING THE FRONT TURN SIGNAL
LIGHT ASSEMBLIES
The following procedure applies to both of the
front turn signal light assemblies.
1. Check:
• Front turn signal light assembly
Faulty → Replace.
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼▼▼▼
a. Disconnect the front turn signal light assem-
bly coupler from the wire harness.
b. Connect the battery (DC 12 V) as shown.
c. Check that the front turn signal light comes
on.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲▲▲▲
EAS28250
CHECKING THE RADIATOR FAN MOTORS
The following procedure applies to both of the
radiator fan motors.
1. Check:
• Radiator fan motor
Faulty/rough movement → Replace.
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Disconnect the radiator fan motor coupler
from the wire harness.
b. Connect the battery (DC 12 V) as shown.
c. Check the radiator fan motor movement.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
EAS28260
CHECKING THE COOLANT TEMPERATURE
SENSOR
1. Remove:
• Coolant temperature sensor
Refer to “THERMOSTAT” on page 6-6.
EWA14130
• Handle the coolant temperature sensor
with special care.
• Never subject the coolant temperature sen-
sor to strong shocks. If the coolant temper-
ature sensor is dropped, replace it.
• Positive battery terminal →
brown or green “1”
• Negative battery terminal →
black “2”
A. Left side
B. Right side
GEAR
A.TEM
C.TEM
• Positive battery terminal →
blue or yellow/blue “1”
• Negative battery terminal →
black “2”
A. Left side
B. Right side
B
Y/L