Yamaha FJR1300A(D) - Page 653

SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
9-10
63 Malfunction code rein-
statement (for fault code
No. 24, 42, 69 only)
• No malfunction code 00 —
• Malfunction code exists Fault code 24, 42, 69
• (If more than one code
number is detected, the
display alternates every
two seconds to show all
the detected code num-
bers.
When all code numbers
are shown, the display
repeats the same pro-
cess.)
To reinstate, set the
start/engine stop switch
from “ ” to “ ”.
67 ISC (idle speed control)
learning condition display
ISC (idle speed control)
learning data erasure
00
ISC (idle speed control)
learning data has been
erased.
01
It is not necessary to
erase the ISC (idle speed
control) learning data.
02
It is necessary to erase
the ISC (idle speed con-
trol) learning data.
To erase the ISC (idle
speed control) learning
data, set the start/engine
stop switch from “ ” to
“ ” 3 times in 5 seconds.
70 Control number 0–254 [-] —
80 Cruise control setting
switch “RES+”
Push and release the
“RES+” side of the cruise
control setting switch.
• Switch is pushed ON
• Switch is released OFF
81 Cruise control setting
switch “SET–”
Push and release the
“SET–” side of the cruise
control setting switch.
• Switch is pushed ON
• Switch is released OFF
Diagnostic
code No.
Item Meter display Procedure