SELF-DIAGNOSTIC FUNCTION AND DIAGNOSTIC CODE TABLE
9-9
60 EEPROM fault code dis-
play
—
• No history 00
• No malfunctions detect-
ed (If the self-diagnosis
fault code 44 is indicat-
ed, the ECU is defec-
tive.)
• History exists 01–04 (Cylinder fault
code)
• (If more than one cylin-
der is defective, the dis-
play alternates every two
seconds to show all the
detected cylinder num-
bers.
When all cylinder num-
bers are shown, the dis-
play repeats the same
process.)
17 (Data error for ISC (idle
speed control) learning
values)
61 Malfunction history code
display
—
• No history 00
• History exists Fault codes 11–91
• (If more than one code
number is detected, the
display alternates every
two seconds to show all
the detected code num-
bers.
When all code numbers
are shown, the display
repeats the same pro-
cess.)
62 Malfunction history code
erasure
• No history 00 —
• History exists • Displays the total num-
ber of malfunctions, in-
cluding the current
malfunction, that have
occurred since the histo-
ry was last erased. (For
example, if there have
been three malfunc-
tions, “03” is displayed.)
To erase the history, set
the start/engine stop
switch from “ ” to “ ”.
Diagnostic
code No.
Item Meter display Procedure
To Next Page
Loading...
