4-68
TRANSMISSION
ENG
25 Nm (2.5 mkg)
NOTE:
NOTE:
TRANSMISSION INSTALLATION
1. Tighten:
Torx screws (bearing retainer)
1
Use #40 torx screw wrench.
2. Lock the torx screw head with drift punch.
3. Install:
Shift cam
1
Shift fork 2 “C”
2
Shift fork 3 “R”
3
Shift fork 1 “L”
4
Guide bar 1
5
Guide bar 2
6
The number stamped into the shift fork must al-
ways face towards the right side of the crank-
case. Be sure that the shift fork guide pin is
properly seated in the shift drum groove.
4. Check:
Shift operation
Unsmooth operation Repair.
Oil each gear and bearing thoroughly.
Before assembling the crankcase, be sure
that the transmission is in neutral and that the
gears turn freely.
To Next Page