3-11
THROTTLE CABLE ADJUSTMENT/
SPARK PLUG INSPECTION
INSP
ADJ
NOTE:
*****************************************************
CAUTION:
1st step:
D Loosen the locknut
3
on throttle cable #1.
D Turn the adjuster
4
in or out until the speci-
fied free play is obtained.
Turning in:
free play is increased.
Turning out: free play is decreased.
D Tighten the locknuts.
If the specified free play cannot be obtained on
the carburetor end of the cable, use the adjuster
on the handlebar end.
Additional step:
D Loosen the locknut
5
.
D Turn the adjuster
6
in or out until the speci-
fied free play is obtained.
Turning in:
free play is increased.
Turning out: free play is decreased.
D Tighten the locknut.
After adjusting, turn the handlebars to the
right and to the left to ensure that this does
not cause the engine idling speed to
change.
4. Install:
S Fuel tank
S Rider’s seat
Refer to “FUEL TANK AND SEATS”.
EB303040
SPARK PLUG INSPECTION
1. Remove:
S Spark plug caps
S Spark plugs
Before removing the spark plugs, use com-
pressed air to blow away any dirt accumu-
lated in the spark plug wells, to prevent it
from falling into the cylinders.