6-3
FRONT WHEEL AND BRAKE DISC
CHAS
*****************************************************
*****************************************************
NOTE:
NOTE:
FRONT WHEEL DISASSEMBLY
1. Remove:
S Oil seals
S Bearings
1
S Collar
Removal steps:
D Clean the outside of the front wheel hub.
D Use a flat-head screwdriver to remove the oil
seals.
To prevent damage place a rag between the
screwdriver and the wheel surface.
D Remove the bearings using a standard bear-
ing puller
2
.
FRONT WHEEL INSPECTION
1. Inspect:
S Front wheel axle
(by rolling it on a flat surface)
Bent Replace.
Do not attempt to straighten a bent axle.
2. Inspect:
S Front tire
Refer to “TIRE INSPECTION” in CHAP-
TER 3.
S Front wheel
Refer to “WHEEL INSPECTION” in
CHAPTER 3.
3. Check:
S Spokes
Bends/damage Replace.
Loose spokes Retighten.
Turn the wheel and tap the spokes with a
screwdriver.
A tight spoke will emit a clear, ringing tone; a
loose spoke will sound flat.
To Next Page