3-16
Temp.
ENGINE OIL LEVEL INSPECTION
INSP
ADJ
NOTE:
CAUTION:
NOTE:
ENGINE OIL LEVEL INSPECTION
1. Stand the motorcycle on a level surface.
D Make sure the motorcycle is upright when in-
specting the oil level.
D Place the motorcycle on a suitable stand.
2. Inspect:
S Oil level
Oil level should be between the maximum
a
and minimum
b
marks.
Oil level is below the minimum mark
Add oil up to the proper level.
Recommended engine oil:
Refer to the chart for selection
of oils suited to the atmosperic
temperature.
API Standard:
API SE or higher grade
D Do not put in any chemical additives or
use oils with a grade of CD
a
or higher.
D Be sure not to use oils labeled “ENERGY
CONSERVING ll”
b
or higher. Engine oil
also lubricates the clutch and additives
could cause clutch slippage.
D Be sure no foreign material enters the
crankcase.
3. Start the engine and let it warm up for sev-
eral minutes.
4. Stop the engine and inspect the oil level
once again.
Wait until the oil settles before inspecting the oil
level.
To Next Page
Loading...
