Yamaha XVS6501997 - Page 260

6-60
SHAFT DRIVE
CHAS
*****************************************************
*****************************************************
NOTE:
*****************************************************
*****************************************************
3. Remove:
S Final drive roller bearing
1
Removal steps:
D Heat the final gear case to 150_C.
D Using an appropriately shaped punch
2
re-
move the roller bearing outer races.
D Remove the inner race from the final drive
shaft.
The removal of the final drive shaft roller bear-
ing is a difficult procedure and is rarely neces-
sary.
4. Install:
S Final drive roller bearing (new)
Installation steps:
D Heat the final gear case to 150_C.
D Install the roller bearing outer races using the
proper adapter.
D Install the inner race onto the drive shaft.
5. Install:
S Guide collar
1
S Oil seal
2
S Roller bearing (outer race)
3
To install the above components into the
final gear case use a suitable press tool
4
and a press.