3-18
ENGINE OIL REPLACEMENT
INSP
ADJ
*****************************************************
*****************************************************
6. Fill:
S Crankcase
Refer to “ENGINE OIL LEVEL INSPEC-
TION”.
Oil quantity:
Total amount:
3.2 L (2.8 Imp qt)
Periodic oil change:
2.6 L (2.3 Imp qt)
With oil filter replacement:
2.8 L (2.6 Imp qt)
7. Install:
S Oil filler plug,
S Warm up the engine for a few minutes,
then turn it off.
8. Check:
S Engine (for oil leaks)
S Oil level
9. Check:
S Oil pressure
Checking steps:
D Slightly loosen the oil gallery bolt
1
.
D Start the engine and keep it idling until oil
starts to seep from the oil gallery bolt. If no oil
comes out after one minute, turn the engine
off so that it will not seize.
D Check the oil passages, oil filter and oil pump
for damage or leakage. Refer to “INSPEC-
TION AND REPAIR” in CHAPTER 4.
D Start the engine after solving the problem(s)
and check the oil pressure again.
D Tighten the oil gallery bolt to specification.
Oil gallery bolt:
8 Nm (0.8 mSkg)
To Next Page
Loading...
