7 218IF Module
7.5.5 Transmission Parameter Settings
7-18
11. Code
Handle the code for the data to be transferred at each connection according to the code
set at the remote station.
• RTU: Specifies RTU mode when the MEMOBUS protocol is being used.
• ASCII: Specifies ASCII mode.
• BIN: Specifies binary mode.
The codes that can be selected depend on the data in the Protocol Type column.
Note: Yes: Selectable, No: Not selectable
12. DST. Station (Remote Station’s Name)
Enter a connection comment of up to 32characters.
Protocol Type Remarks
Extended
MEMOBUS
Yaskawa Extended MEMOBUS protocol.
MEMOBUS Yaskawa Standard MEMOBUS protocol.
MELSEC Mitsubishi Electric’s Ethernet Interface protocol for use with general-
purpose sequencers.
No protocol General-purpose message communications. Data is transmitted and
received without being processed into consecutive MW registers.
Table 7.4 Selectable Codes
Protocol Type Code
RTU ASCII BIN
Extended MEMOBUS
No Yes Yes
Extended MEMOBUS
No Yes Yes
MEMOBUS
Yes Yes N o
MELSEC
No Yes Yes
No protocol
No Yes Yes
To Next Page
Loading...
