YASKAWA SGD7S series - Page 583

14.1 List of Parameters
14.1.2 List of Parameters
14-10
Pn00F
2
Application Function
Selections F
0000 hex
to
2011 hex
−
0000
hex
All
After
restart
Setup
−
Pn010 2
Axis Address Selection
for UART/USB Commu-
nications
0000 hex
to
007F hex
−
0001
hex
All
After
restart
Setup
−
Pn021 2
Reserved parameter (Do
not change.)
−−
0000
hex
All
−−−
Pn022 2
Reserved parameter (Do
not change.)
−−
0000
hex
All
−−−
Pn040
2
Σ-V Compatible Func-
tion Switch
0000 hex
to
2111 hex
−
0000
hex
−
After
restart
Setup
−
Pn080
2
Application Function
Selections 80
0000 hex
to
1111 hex
−
0000
hex
Linear
After
restart
Setup
−
Continued on next page.
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence
n.X
Preventative Maintenance Warning Selection Reference
0 Do not detect preventative maintenance warnings.
page 9-17
1 Detect preventative maintenance warnings.
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X
Encoder Resolution Compatibility Selection
Applicable
Motors
0 Use the encoder resolution of the connected motor.
Rotary
1
Use a resolution of 20 bits when connected to an SGM7J,
SGM7A, SGM7P, or SGM7G Servomotor.
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X
Polarity Sensor Selection Reference
0 Use polarity sensor.
page 5-26
1 Do not use polarity sensor.
n.X
Motor Phase Sequence Selection Reference
0 Set a phase-A lead as a phase sequence of U, V, and W.
page 5-24
1 Set a phase-B lead as a phase sequence of U, V, and W.
n.X Reserved parameter (Do not change.)
n.X
Calculation Method for Maximum Speed or Encoder Output Pulses Reference
0
Calculate the encoder output pulse setting for a fixed maximum
speed.
page 15-8
1
Calculate the maximum speed for a fixed encoder output pulse
setting.