YASKAWA SGD7S series - Page 582

14.1 List of Parameters
14.1.2 List of Parameters
14
Parameter Lists
14-9
Pn00B
2
Application Function
Selections B
0000 hex
to
1121 hex
−
0000
hex
All
After
restart
Setup
−
Pn00C
2
Application Function
Selections C
0000 hex
to
0131 hex
−
0000
hex
−
After
restart
Setup
page
7-27
Pn00D
2
Application Function
Selections D
0000 hex
to
1001 hex
−
0000
hex
All
After
restart
Setup
page
5-34
Continued on next page.
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence
n.X
Operator Parameter Display Selection Reference
0 Display only setup parameters.
page 5-4
1 Display all parameters.
n.X
Motor Stopping Method for Group 2 Alarms Reference
0 Stop the motor by setting the speed reference to 0.
page 5-421
Apply the dynamic brake or coast the motor to a stop (use the
stopping method set in Pn001 = n.X).
2 Set the stopping method with Pn00A = n.X.
n.X
Power Input Selection for Three-phase SERVOPACK Reference
0 Use a three-phase power supply input.
page 5-14
1
Use a three-phase power supply input as a single-phase power
supply input.
n.X Reserved parameter (Do not change.)
n.X
Function Selection for Test without a Motor
Applicable
Motors
0 Disable tests without a motor.
All
1 Enable tests without a motor.
n.
X
Encoder Resolution for Tests without a Motor
Applicable
Motors
0Use 13 bits.
Rotary
1Use 20 bits.
2Use 22 bits.
3Use 24 bits.
n.X
Encoder Type Selection for Tests without a Motor
Applicable
Motors
0 Use an incremental encoder.
All
1 Use an absolute encoder.
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X Reserved parameter (Do not change.)
n.X
Overtravel Warning Detection Selection
0 Do not detect overtravel warnings.
1 Detect overtravel warnings.