YASKAWA SGD7S series - Page 595

14.1 List of Parameters
14.1.2 List of Parameters
14-22
Pn50A
2
Input Signal Selections
1
0000 hex to
FFF2 hex
−
2100
hex
All
After
restart
Setup
−
Continued on next page.
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence
n.X
Input Signal Allocation Mode Reference
0
Use the sequence input signal terminals with the default alloca-
tions.
page 6-5
1 Change the sequence input signal allocations.
2 Reserved setting (Do not use.)
n.X
/S-ON (Servo ON) Signal Allocation Reference
0 Active when CN1-40 input signal is ON (closed).
page 5-17
1 Active when CN1-41 input signal is ON (closed).
2 Active when CN1-42 input signal is ON (closed).
3 Active when CN1-43 input signal is ON (closed).
4 Active when CN1-44 input signal is ON (closed).
5 Active when CN1-45 input signal is ON (closed).
6 Active when CN1-46 input signal is ON (closed).
7 The signal is always active.
8 The signal is always inactive.
9 Active when CN1-40 input signal is OFF (open).
A Active when CN1-41 input signal is OFF (open).
B Active when CN1-42 input signal is OFF (open).
C Active when CN1-43 input signal is OFF (open).
D Active when CN1-44 input signal is OFF (open).
E Active when CN1-45 input signal is OFF (open).
F Active when CN1-46 input signal is OFF (open).
n.X
/P-CON (Proportional Control) Signal Allocation Reference
0 to F
The allocations are the same as the /S-ON (Servo ON) signal allo-
cations.
page 8-74
n.X
P-OT (Forward Drive Prohibit) Signal Allocation Reference
0 Enable forward drive when CN1-40 input signal is ON (closed).
page 5-31
1 Enable forward drive when CN1-41 input signal is ON (closed).
2 Enable forward drive when CN1-42 input signal is ON (closed).
3 Enable forward drive when CN1-43 input signal is ON (closed).
4 Enable forward drive when CN1-44 input signal is ON (closed).
5 Enable forward drive when CN1-45 input signal is ON (closed).
6 Enable forward drive when CN1-46 input signal is ON (closed).
7 Set the signal to always prohibit forward drive.
8 Set the signal to always enable forward drive.
9 Enable forward drive when CN1-40 input signal is OFF (open).
A Enable forward drive when CN1-41 input signal is OFF (open).
B Enable forward drive when CN1-42 input signal is OFF (open).
C Enable forward drive when CN1-43 input signal is OFF (open).
D Enable forward drive when CN1-44 input signal is OFF (open).
E Enable forward drive when CN1-45 input signal is OFF (open).
F Enable forward drive when CN1-46 input signal is OFF (open).