YASKAWA SGD7S series - Page 599

14.1 List of Parameters
14.1.2 List of Parameters
14-26
Pn50E
2
Output Signal Selec-
tions 1
0000 hex to
6666 hex
−
3211
hex
All
After
restart
Setup
−
Pn50F
2
Output Signal Selec-
tions 2
0000 hex to
6666 hex
−
0000
hex
All
After
restart
Setup
−
Continued on next page.
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence
n.X
/COIN (Positioning Completion Output) Signal Allocation Reference
0 Disabled (the above signal output is not used).
page 6-37
1 Output the signal from the CN1-25 or CN1-26 output terminal.
2 Output the signal from the CN1-27 or CN1-28 output terminal.
3 Output the signal from the CN1-29 or CN1-30 output terminal.
4 Output the signal from the CN1-37 output terminal.
5 Output the signal from the CN1-38 output terminal.
6 Output the signal from the CN1-39 output terminal.
n.X
/V-CMP (Speed Coincidence Detection Output) Signal Allocation Reference
0 to 6
The allocations are the same as the /COIN (Positioning Comple-
tion) signal allocations.
page 6-27
n.X
/TGON (Rotation Detection Output) Signal Allocation Reference
0 to 6
The allocations are the same as the /COIN (Positioning Comple-
tion) signal allocations.
page 6-11
n.X
/S-RDY (Servo Ready) Signal Allocation Reference
0 to 6
The allocations are the same as the /COIN (Positioning Comple-
tion) signal allocations.
page 6-12
n.X
/CLT (Torque Limit Detection Output) Signal Allocation Reference
0 Disabled (the above signal output is not used).
page 6-72
1 Output the signal from the CN1-25 or CN1-26 output terminal.
2 Output the signal from the CN1-27 or CN1-28 output terminal.
3 Output the signal from the CN1-29 or CN1-30 output terminal.
4 Output the signal from the CN1-37 output terminal.
5 Output the signal from the CN1-38 output terminal.
6 Output the signal from the CN1-39 output terminal.
n.X
/VLT (Speed Limit Detection) Signal Allocation Reference
0 to 6
The allocations are the same as the /CLT (Torque Limit Detection
Output) signal allocations.
page 6-45
n.X
/BK (Brake Output) Signal Allocation Reference
0 to 6
The allocations are the same as the /CLT (Torque Limit Detection
Output) signal allocations.
page 5-36
n.X
/WARN (Warning Output) Signal Allocation Reference
0 to 6
The allocations are the same as the /CLT (Torque Limit Detection
Output) signal allocations.
page 6-11