YASKAWA SGD7S series - Page 606

14.1 List of Parameters
14.1.2 List of Parameters
14
Parameter Lists
14-33
*1. Set a percentage of the motor rated torque.
*2. These parameters are for SERVOPACKs with a Safety Module. Refer to the following manual for details.
Σ-V-Series/Σ-V-Series for Large-Capacity Models/Σ-7-Series User’s Manual Safety Module (Manual No.: SIEP
C720829 06)
*3. Normally set this parameter to 0. If you use an External Regenerative Resistor, set the capacity (W) of the Exter-
nal Regenerative Resistor.
*4. The upper limit is the maximum output capacity (W) of the SERVOPACK.
*5. These parameters are for SERVOPACKs with the dynamic brake option. Refer to the following manual for details.
Σ-7-Series AC Servo Drive Σ-7S/Σ-7W SERVOPACK with Dynamic Brake Hardware Option Specifications Prod-
uct Manual (Manual No.: SIEP S800001 73)
*6. The SGLFW2 is the only Yaskawa Linear Servomotor that supports this function.
*7. Enabled only when Pn61A is set to n.2 or n.3.
Pn61B
*7
2 Overheat Alarm Level 0 to 500 0.01 V 250 All
Immedi-
ately
Setup
page
6-109
Pn61C
*7
2 Overheat Warning Level 0 to 100 1% 100 All
Immedi-
ately
Setup
page
6-109
Pn61D
*7
2
Overheat Alarm Filter
Time
0 to 65,535 1 s 0 All
Immedi-
ately
Setup
page
6-109
Pn621 to
Pn628
*2
–
Safety Module-Related
Parameters
−−−
All
−−−
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence