YASKAWA T1000A - Page 501

E.3 User Setting Table
YASKAWA ELECTRIC SIEP C710616 30B YASKAWA AC Drive T1000A Technical Manual 501
Quick Reference Sheet
E
S5-03

KEB Decel Time Switching Frequency
S5-04

KEB Decel Time Switching Time
S5-05

KEB Synchronous Acceleration Time
S5-06

S-Curve at KEB Deceleration Start
S5-07

Frequency Gain at KEB Start during Constant Speed
S5-08

Frequency Gain at KEB Start during Acceleration
S5-09

Frequency Gain at KEB Start during Deceleration
S5-10 Synchronous Deceleration ov Prevention
S5-11

KEB Frequency Reduction Step Lower Limit
S6-01 DC Bus Capacity
S6-02 Motor Acceleration Time
S6-03 Load/Inertia Ratio
S6-04 Main Circuit Voltage Adjustment Gain
S6-05 Accel/Decel Calculation Gain
S6-06 ASR Primary Delay Time Constant 2
S6-07 Torque Limit Delay Time
S9-03 Speed Detection Change Rate Limit
S9-06 Speed Detection Width After Coasting
T1-00 Motor 1/Motor 2 Selection
T1-01 Auto-Tuning Mode Selection
T1-02 Motor Rated Power
T1-03 Motor Rated Voltage
T1-04 Motor Rated Current
T1-05 Rated Frequency
T1-06 Number of Motor Poles
T1-07 Rated Speed
T1-08 PG Number of Pulses Per Revolution
T1-09 Motor No-Load Current
T1-10 Motor Rated Slip
T1-11 Motor Iron Loss
T2-01 PM Motor Auto-Tuning Mode Selection
T2-02 PM Motor Code Selection
T2-03 PM Motor Type
T2-04 PM Motor Rated Power
T2-05 PM Motor Rated Voltage
T2-06 PM Motor Rated Current
T2-07 PM Motor Rated Frequency
T2-08 Number of PM Motor Poles
T2-09 PM Motor Rated Speed
T2-10 PM Motor Stator Resistance
T2-11 PM Motor d-Axis Inductance
T2-12 PM Motor q-Axis Inductance
T2-13 Induced Voltage Constant Unit Selection
T2-14 PM Motor Induced Voltage Constant
T2-15 Pull-In Current Level for PM Motor Tuning
T2-16
PG Number of Pulses Per Revolution for PM Motor
Tuning
T2-17 Encoder Z-Pulse Offset
T3-01 Inertia Tuning Frequency Reference
T3-02 Inertia Tuning Reference Amplitude
T3-03 Motor Inertia
T3-04 ASR Response Frequency
No. Name
User
Setting