Zebra DS6878 Product Reference Guide

5 - 14 DS6878 Product Reference Guide
Night Mode Trigger
Parameter # 1215
For DS6878-HC units only, manufactured after xx/xx/2013
Enable this to use the trigger to toggle between entering and exiting Night Mode. To toggle, point the scanner away
from a bar code, pull the trigger until the beam goes off, and then continue pulling the trigger for an additional 5
seconds. Note that pulling the trigger an additional 5 seconds after decoding a bar code has no affect.
When entering Night Mode, the pager motor vibrates. When exiting Night Mode, the scanner emits 2 short beeps.
Night Mode Toggle
For DS6878-HC units only, manufactured after xx/xx/2013
To toggle between entering and exiting Night Mode without using the trigger, scan this bar code. This functions
regardless of the state of the Night Mode Trigger parameter.
When scanning this bar code, the Pager Motor vibrates when entering Night Mode, and the scanner emits 2 short
beeps when exiting Night Mode.
Enable Night Mode Trigger
(1)
*Disable Night Mode Trigger
(0)
Toggle Night Mode

Zebra DS6878 Specifications

General

Wavelength	655 nm
Scanner type	2D
Yaw reading angle	-60 - 60 °
Decoding standards	1D, 2D, PDF417, PDF417, microPDF417, Composite Codes (CC-A, CC-B, CC-C), U.S. Postnet and Planet, U.K., Japan, Australian, Netherlands KIX code, Royal Mail 4 State Customer, UPU ICS 4 State Postal, USPS 4CB, TL C-39, Aztec (Standard, Inverse), MaxiCode, DataMatrix/ECC 200 (Standard, Inverse), QR Code (Standard, Inverse and Micro)
Tilt reading angle	-360 - 360 °
Input voltage	5 V
Bluetooth	Yes
Dimensions (WxDxH)	69 x 97 x 185 mm
Certification	FCC, RoHS
Product color	Black
International Protection (IP) code	IP43
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Cables included	USB

Weight and Dimensions

Weight	238 g