RS-232 Interface 8 - 17
Nixdorf Beep/LED Options
When Nixdorf Mode B is selected, this indicates when the digital scanner beeps and turns on its LED after a
decode.
Ignore Unknown Characters
Unknown characters are characters the host does not recognize. When Send Bar Codes with Unknown
Characters is selected, all bar code data is sent except for unknown characters, and no error beeps sound on
the digital scanner. When Do Not Send Bar Codes With Unknown Characters is selected, bar code data is
sent up to the first unknown character and then an error beep sounds on the digital scanner.
*Normal Operation
(Beep/LED immediately after decode)
Beep/LED After Transmission
Beep/LED After CTS Pulse
*Send Bar Code with Unknown Characters
Do Not Send Bar Codes with Unknown Characters
To Next Page
Loading...
