Zebra DS6878 - Snapshot Mode Timeout; Snapshot Aiming Pattern; Image Cropping

Imaging Preferences 6 - 7
Snapshot Mode Timeout
Parameter # 323
This parameter sets the amount of time the digital scanner remains in Snapshot Mode. The digital scanner
exits Snapshot Mode when you pull the trigger, or when the Snapshot Mode Timeout elapses. To set this
timeout value, scan the bar code below followed by a bar code from Appendix D, Numeric Bar Codes. The
default value is 0 which represents 30 seconds; values increment by 30. For example, 1 = 60 seconds, 2 = 90
seconds, etc.
Snapshot Aiming Pattern
Parameter # 300
Select Enable Snapshot Aiming Pattern to project the aiming pattern when in Snapshot Mode, or Disable
Snapshot Aiming Pattern to turn the aiming pattern off.
Image Cropping
Parameter # 301
This parameter crops a captured image. Select Disable Image Cropping to present the full 752 x 480 pixels.
Select Enable Image Cropping to crop the image to the pixel addresses set in Crop to Pixel Addresses on
page 6-8.
Snapshot Mode Timeout
*Enable Snapshot Aiming Pattern
(1)
Disable Snapshot Aiming Pattern
(0)
Enable Image Cropping
(1)
*Disable Image Cropping
(Use Full 752 x 480 Pixels)
(0)