Zebra DS6878 - Quick Keypad Emulation; USB Keyboard FN 1 Substitution

USB Interface 7 - 13
Quick Keypad Emulation
This option applies only to the USB Keyboard (HID) device and if Emulate Keypad is enabled. This parameter
enables a quicker method of keypad emulation where ASCII sequences are only sent for ASCII characters not
found on the keyboard. The default value is Disable.
USB Keyboard FN 1 Substitution
This option applies only to the USB Keyboard (HID) device. When enabled, this allows replacement of any FN
1 characters in an EAN 128 bar code with a Key Category and value chosen by the user (see FN1 Substitution
Values on page 5-50 to set the Key Category and Key Value).
Enable
*Disable
Enable FN1 Substitution
*Disable FN1 Substitution