Zebra DS6878 Product Reference Guide

4 - 20 DS6878 Product Reference Guide
Auto-reconnect in Bluetooth Keyboard Emulation (HID Slave) Mode
In Bluetooth Keyboard Emulation (HID Slave) mode, select a re-connect option for when the digital scanner
loses its connection with a remote device:
• Auto-reconnect on Bar Code Data: The digital scanner auto-reconnects when you scan a bar code.
With this option, a delay can occur when transmitting the first characters. The digital scanner sounds a
decode beep upon bar code scan, followed by a connection, a page timeout, a rejection beep, or a
transmission error beep. Select this option to optimize battery life on the digital scanner and mobile
device. Note that auto-reconnect does not occur on rejection and cable unplug commands.
• Auto-reconnect Immediately: When the digital scanner loses connection, it attempts to reconnect. If a
page timeout occurs, the digital scanner attempts reconnect on a trigger pull. Select this option if the
digital scanner’s battery life is not an issue and you do not want a delay to occur when the first bar code
is transmitted. Note that auto-reconnect does not occur on rejection and cable unplug commands.
• Disable Auto-reconnect: When the digital scanner loses connection, you must re-establish it manually.
Out of Range Indicator
An out of range indicator can be set by scanning Enable Beep on Reconnect Attempt on page 4-18 and
extending the time using the Reconnect Attempt Interval on page 4-19.
For example, with Beep on Reconnect Attempt disabled while the digital scanner loses radio connection when
it is taken out of range, the digital scanner attempts to reconnect silently during the time interval set by
scanning a Reconnect Attempt Interval.
When Beep on Reconnect Attempt is enabled, the digital scanner emits 5 high beeps every 5 seconds while
the reconnection attempt is in progress. If the Reconnect Attempt Interval is adjusted to a longer period of time,
such as 30 minutes, the digital scanner emits 5 high beeps every 5 seconds for 30 minutes providing an out of
range indicator.
*Auto-reconnect on Bar Code Data
Auto-reconnect Immediately
Disable Auto-reconnect

Zebra DS6878 Specifications

General

Wavelength	655 nm
Scanner type	2D
Yaw reading angle	-60 - 60 °
Decoding standards	1D, 2D, PDF417, PDF417, microPDF417, Composite Codes (CC-A, CC-B, CC-C), U.S. Postnet and Planet, U.K., Japan, Australian, Netherlands KIX code, Royal Mail 4 State Customer, UPU ICS 4 State Postal, USPS 4CB, TL C-39, Aztec (Standard, Inverse), MaxiCode, DataMatrix/ECC 200 (Standard, Inverse), QR Code (Standard, Inverse and Micro)
Tilt reading angle	-360 - 360 °
Input voltage	5 V
Bluetooth	Yes
Dimensions (WxDxH)	69 x 97 x 185 mm
Certification	FCC, RoHS
Product color	Black
International Protection (IP) code	IP43
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Cables included	USB

Weight and Dimensions

Weight	238 g