Zebra DS6878 - Wand Emulation Parameter Defaults

Wand Emulation Interface 11 - 3
Wand Emulation Parameter Defaults
Table 11-1 lists the defaults for Wand Emulation host types. To change any option, scan the appropriate bar
code(s) provided in Wand Emulation Host Parameters beginning on page 11-4.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 11-1 Wand Emulation Default Parameters
Parameter Default
Page
Number
Wand Emulation Host Parameters
Wand Emulation Host Types
Symbol OmniLink Interface Controller
1
11-4
Leading Margin 80 msec 11-4
Polarity Bar High/Margin Low 11-5
Ignore Unknown Characters Send 11-5
Convert All Bar Codes to Code 39 Disable 11-6
Convert Code 39 to Full ASCII Disable 11-6
1
User selection is required to configure this interface and this is the most common selection.