CHAPTER 11 WAND EMULATION
INTERFACE
Introduction
This chapter provides instructions for programming the cradle to interface with a wand emulation host. This
mode is used whenever wand emulation communication is needed. The digital scanner cradle connects either
to an external wand decoder or to a decoder integrated in a portable terminal or Point-of-Sale (POS) terminal.
In this mode the digital scanner emulates the signal of a digital wand to make it “readable” by a wand decoder.
Throughout the programming bar code menus, default values are indicated with asterisks (
*).
*Transmit Unknown Characters
Feature/Option* Indicates Default
To Next Page
Loading...
