Zebra DS6878 - RS-232 Parameter Defaults

RS-232 Interface 8 - 3
RS-232 Parameter Defaults
Table 8-1 lists the defaults for RS-232 host parameters. If any option needs to be changed, scan the
appropriate bar code(s) provided in the Parameter Descriptions section beginning on page 8-4.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 8-1 RS-232 Host Default Parameters
Parameter Default
Page
Number
RS-232 Host Parameters
RS-232 Host Types Standard 8-6
Baud Rate 9600 8-8
CR0078-P Baud Rate None 8-8
Parity Type None 8-9
Data Bits (ASCII Format) 8-Bit 8-9
Check Receive Errors Enable 8-10
Hardware Handshaking None 8-10
Software Handshaking None 8-12
Host Serial Response Time-out 2 sec 8-14
RTS Line State Low RTS 8-15
Beep on <BEL> Disable 8-15
Intercharacter Delay 0 msec 8-16
Nixdorf Beep/LED Options Normal Operation 8-17
Ignore Unknown Characters Send Bar Code 8-17