GDP-32
II
INSTRUCTION MANUAL
May 2002 Section 7, Page 18
7.8 UP-LOADING PROGRAM FILES VIA NETWORK
Program files are stored on the PCMCIA Flash card disk (drive C:). These files can be accessed
and transferred by using Windows Explorer. When the GDP-32
II
is connected to a Local Area
Network, any other computer on the network can also see the GDP’s disk drives. File transfer is
now facilitated by dragging and dropping the files on the GDP to any desired folder on any other
computer.
NOTE: Time series files and the cache files can also be transferred with this method.
TO TRANSFER TIME-SERIES FILES:
1. Turn OFF the GDP.
2. Connect the GDP-32
II
to the network using the multi-function interface cable.
NOTE: This special cable is supplied by Zonge Engineering (P/N: GDP-32/2-ACC).
3. Start the GDP and get into Windows.
4. The GDP-32
II
is configured by default with no network password. It is also set to
obtain its IP address automatically. Its name is set to appear as GDP32IISNxx, where
xx is the front panel serial number. Its default workgroup is “ENGINEERING”.
5. Once Windows is running, the GDP-32
II
should appear in the Network Neighborhood
of the other computers on the network. Now you can easily transfer files to other
computers.
NOTE: The program files are stored in the directory C:\.
6. Exit Windows on the GDP as you would any other computer.
To Next Page
Loading...
