Zonge GDP-32 - Receiver Start-Up

QUICK START
Section 4, Page 3 October 2003
4.2 RECEIVER START-UP
1. Power Up the receiver by cycling the Power ON/OFF button on the Control I/O
panel. This applies power to the oven-stabilized Crystal Oscillator and illuminates
the Crystal Oscillator Power Light on the Front Panel.
2. Press the
ON/OFF
button located
on the Front Panel. The unit
beeps and the LCD displays the
initializing parameters for the
digital section.
3. After adjusting
CONTRAST
on the
screen (if necessary), press
Enter
or and wait for
the unit to verify the caches and
analog channels.
12 Jan 00 16:45:07
Initializing: Please stand by.
Cache Freq Domain Cal validated.
Cache Time Domain Cal validated.
Cache Antenna Cal validated.
Cache CR Calibrate validated.
Cache CR Antenna Cal validated.
Cache AMT Calibrate validated.
Cache AMT Antenna Cal validated.
Cache Field Data validated.
Cache memory approximately 11542 KB
Timing board initialized.
Calibration board initialized.
Resetting analog boards.