RPIP PROGRAM
Section 8, Page 13 January 2003
SAMPLE DATA BLOCKS
Data are exported to a computer in the following format:
These data were acquired using an RC network and a constant current laboratory transmitter.
The RC network is as follows:
Block 0008 is the Program Data Header. A new Program Data Header is written to the data
cache whenever the operator returns to the Operation Information Screen.
Block 0009 is the Data Block and is written to the data cache when
Enter
is pressed at the end
of each data acquisition cycle.
50 K
50 K
1 uF
Program Data Header
Main Data Block
Dipole-Dipole array used Card status:
Gain factors
Analog card
modification level indicator
SEM's in mr
SP in mv
Contact Resistance in ohms
Passed or Failed
QC test
for each card
information
0003
0004
1 DiffAmp Notch+60,3-50,3 S/N 185 Passed 1.00192
1 ON 1 211.60m 2.6 398.9 030O .47 2.96 1.23K
OPER 1 TX ID 1 A-SP 100.0
TDIP0528 94-03-15 14:44:02 12.6v D-D
JOB 91001 LINE 1 N SPREAD 1
4 DiffAmp Notch+60,3-50,3 S/N 57 Passed 1.00329
2 DiffAmp Notch+60,3-50,3 S/N 177 Passed 0.99835
3 DiffAmp Notch+60,3-50,3 S/N 61 Passed 0.99921
5 DiffAmp Notch+60,3-50,3 S/N 60 Passed 0.99876
6 DiffAmp Notch+60,3-50,3 S/N 66 Passed 0.99586
Tx 1 Rx 3 N OUT
TDIP0528 94-03-15 14:55:48 12.6v D-D
.125 Hz 4 Cyc Tx Curr 1.00
3 ON 3 212.16m 2.6 3.999K 030O .47 -0.56 1.02K
5 ON 5 211.76m 2.6 13.97K 030O .48 -3.56 1.17K
2 ON 2 212.13m 2.6 1.599K 030O .47 0.12 690.1
4 ON 4 211.96m 2.6 7.991K 030O .46 -1.78 2.27K
6 ON 6 212.09m 2.6 22.39K 030O .47 -5.92 1.63K
To Next Page
Loading...
