COMPLEX RESISTIVITY & HACSAMT PROGRAM
Section 10, Page 19 January 2003
These data were acquired using an RC network and a constant current laboratory transmitter.
The RC network is as follows:
Block 0005 is the program header and is written to the data cache only when the operator goes
between Menu 2 and 3.
Block 0006 is the main data block and is written at the end of each data acquisition cycle, when
Enter
is pressed in answer to the instruction: "CONTINUE to save, RESET to
discard". This data block is an example of non-reference CR or harmonic RP/IP.
Block 0007 contains the referenced CR data and is of the same form as that shown previously.
50 K
50 K
1 uF
To Next Page
Loading...
