MAINTENANCE
Section 17, Page 23 May 2002
Replacing Faulty Batteries - Small Case
The batteries for the small case GDP-32
II
T are secured in the battery compartment accessible by
removing the front panel.
1. Remove the 4 screws securing the lid to the battery compartment.
2. Lift each battery out and remove the spade lugs that connect the battery cable harness to
the battery. Note that some batteries may have the wiring harnesses soldered to the
battery lugs.
3. Replace the old batteries with two new 10.0 A-h, 6 V sealed-lead acid batteries (YUASA
Type NP10-6)
Replacing Faulty Batteries - Large Case
1. Use a non-metallic object to gently pry each cell up to that it can be grasped and
removed.
2. Replace the old batteries with four new 10.0 A-h, 6 V sealed lead-acid batteries (YUASA
Type NP10-6).
3. Note that some batteries may have the wiring harnesses soldered to the battery lugs.
To Next Page
Loading...
