QUICK START
Section 4, Page 11 October 2003
4.5 SYSTEM CHECK
System checks are performed from the
Data Acquisition Screen of the Survey
Program to be checked.
SYSTEM CHECK SUMMARY
1. Set the frequency value to
check (e.g. 0.125 Hz )
2. Press the
function key.
You can now select between the
Calibrate and System Check
Mode.
3. Press
, System Check or
, Auto System Check.
4. NOTE: In the “Auto System Check” mode, the program automatically goes from the
frequency selected in Step 1 above, to the highest frequency available for the selected
Survey Program until
Escape
is pressed.
5. Press
for “Internal”
voltage source.
0151 RPIP0613 11.7 26 Jan 00 20:31:58
Survey D-D
Tx 1Rx 700N 60, 5
1 Hz 16 Cycles Tx Curr 8
1) Create new calibrate records
2) System check
3) Auto system check
4) Set calibrate voltage
(Press 1 – 4, ESCAPE):
0151 RPIP0613 11.7 26 Jan 00 20:33:46
Survey D-D
Tx 1Rx 700N 60, 5
1 Hz 16 Cycles Tx Curr 8
1) Internal
2) External
(Press 1 – 2, ESCAPE):
To Next Page
Loading...
