Figure 6-26 Preparing control cables for sealing modules 150
Figure 6-27 Preparing auxiliary control cables for cable glands 151
Figure 6-28 Preparing the screens of control cables for EMC
plates 152
Figure 6-29 Preparing control cables for EMC plates 153
Figure 6-30 Top cable entry of 600 mm COU 154
Figure 6-31 Cable route in COU (600 mm) top cable entry 154
Figure 6-32 Cable route in COU (1000 mm) top cable entry 155
Figure 6-33 Cable route in COU (600 mm) bottom cable
entry 155
Figure 6-34 Cable route in COU (1000 mm) bottom cable
entry 156
Figure 6-35 Shield grounding point for encoder cable on NTAC
pulse encoder (A) and synchronous serial interface
(B) 157
Figure 6-36 Cable routing examples in an EXU cabinet with
an ED5V, EB5R, EB5S, EB7P and EB7Q type
DCS800 converter (A) and in an EXU cabinet with
an ED7Y type DCS800 converter 158
Figure 6-37 DCS800 converter (ED5V, EB5R, EB5S, EB7P and
EB7Q types) 160
Figure 6-38 COM-8x circuit board (A) in a DCS800 converter
(ED5V, EB5R and EB5S types) and a detail of
channel CH0 (B) on the board. 160
Figure 6-39 Cable routing example in an EXU cabinet with an
ED5V, EB5R, EB5S, EB7P or EB7Q type DCS800
converter 161
Figure 6-40 DCS800 converter (ED7Y) 162
Figure 6-41 COM-8x circuit board (A) in a DCS800 converter
(ED7Y type) and a detail of channel CH0 (B) on
the board 162
Figure 6-42 Cable routing example in an EXU cabinet with an
ED5V, EB5R or EB5S type DCS800 converter 163
To Next Page
Loading...
