ABB ACS880 - Page 160

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
Reservedb6
Reservedb7…15
1 = 10000h…FFFFh
- / uint16Drive inhibit status word 2. This word specifies the source
of the inhibiting condition that is preventing the drive from
starting. After the condition is removed, the start command
must be cycled. See bit-specific notes.
See also parameter 6.18 Start inhibit status word, and 6.16
Drive status word 1, bit 1.
This parameter is read-only.
Note:
•
If bit 1 of 6.16 Drive status word 1 is still set after the
removal of the inhibiting condition, and edge triggering
is selected for the active external control location, a
fresh rising-edge start signal is required. See
parameters 20.2, 20.7 and 20.19.
•
If bit 1 of 6.16 Drive status word 1 is still set after the
removal of the inhibiting condition, a fresh rising-edge
start signal is required.
Drive inhibit status
word 2
6.25
1 = A follower is preventing the master from starting.Follower driveb0
1 = The application program is preventing the drive from
starting.
Applicationb1
Reservedb2
1 = The encoder feedback configuration is preventing the
drive from starting.
Encoder feedbackb3
1 = A reference source parametrization conflict is
preventing the drive from starting. See warning A6DA
Reference source parametrization.
Ref source
parametrization
b4
Reservedb5…15
1 = 10000h…FFFFh
Above limit / uint32Selects a binary source whose status is transmitted as bit
10 of 6.11 Main status word.
MSW bit 10 sel6.29
00False
11True
2
Bit 10 of 6.17 Drive status word 2 (page 156).
Above limit
See Terms and abbreviations (page 132).
Other [bit]
Ext ctrl loc / uint32Selects a binary source whose status is transmitted as bit
11 of 6.11 Main status word.
MSW bit 11 sel6.30
00False
11True
2
Bit 11 of 6.1 Main control word (page 155).
Ext ctrl loc
See Terms and abbreviations (page 132).
Other [bit]
160 Parameters