ABB ACS880 - Page 573

What to doCause
Event name /
Aux. code
Code
(hex)
Contact your local ABB representative.Absolute encoder communication
error.
0008
Contact your local ABB representative.Absolute encoder initialization error.0009
Contact your local ABB representative.Absolute SSI encoder configuration
error.
000A
See the documentation of the encoder.Encoder reported an internal error.000B
See the documentation of the encoder.Encoder reported a battery error.000C
See the documentation of the encoder.Encoder reported overspeed or
decreased resolution due to
overspeed.
000D
See the documentation of the encoder.Encoder reported a position counter
error.
000E
See the documentation of the encoder.Encoder reported an internal error.000F
Check PC tool or control panel
connection.
Control panel (or PC tool) has stopped
communicating.
Control panel
loss
A7EE
Check control panel connector.
Check mounting platform if being used.
Disconnect and reconnect the control
panel.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an ontime timer
or a value counter.
Motor bearingA880
0: 33.13 On-time 1 source
1: 33.23 On-time 2 source
4: 33.53 Value counter 1 source
5: 33.63 Value counter 2 source.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an edge counter.
Programmable warnings:
33.35 Edge counter 1 warn message
Output relayA881
2: 33.33 Edge counter 1 source
33.45 Edge counter 2 warn message
3: 33.43 Edge counter 2 source.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an edge counter.
Programmable warnings:
33.35 Edge counter 1 warn message
Motor startsA882
2: 33.33 Edge counter 1 source
33.45 Edge counter 2 warn message
3: 33.43 Edge counter 2 source.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an edge counter.
Programmable warnings:
33.35 Edge counter 1 warn message
Power upsA883
2: 33.33 Edge counter 1 source
33.45 Edge counter 2 warn message
3: 33.43 Edge counter 2 source.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an edge counter.
Programmable warnings:
33.35 Edge counter 1 warn message
Main contactorA884
2: 33.33 Edge counter 1 source
33.45 Edge counter 2 warn message
3: 33.43 Edge counter 2 source.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an edge counter.
Programmable warnings:
33.35 Edge counter 1 warn message
DC chargeA885
2: 33.33 Edge counter 1 source
33.45 Edge counter 2 warn message
3: 33.43 Edge counter 2 source.
Fault tracing 573