ABB ACS880 - Page 574

What to doCause
Event name /
Aux. code
Code
(hex)
Check the source of the warning
(parameter 33.13 On-time 1 source).
Warning generated by on-time timer 1.On-Time 1A886
Check the source of the warning
(parameter 33.23 On-time 2 source).
Warning generated by on-time timer 2.On-Time 2A887
Check the source of the warning
(parameter 33.33 Edge counter 1
source).
Warning generated by edge counter 1.Edge counter 1A888
Check the source of the warning
(parameter 33.43 Edge counter 2
source).
Warning generated by edge counter 2.Edge counter 2A889
Check the source of the warning
(parameter 33.53 Value counter 1
source).
Warning generated by value counter 1.Value counter
1
A88A
Check the source of the warning
(parameter 33.63 Value counter 2
source).
Warning generated by value counter 2.Value counter
2
A88B
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an ontime timer.
Programmable warnings:
33.14 On-time 1 warn message
Device cleanA88C
0: 33.13 On-time 1 source
33.24 On-time 2 warn message
1: 33.23 On-time 2 source
10: 5.4 Main fan on-time counter.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an ontime timer.
Programmable warnings:
33.14 On-time 1 warn message
DC capacitorA88D
0: 33.13 On-time 1 source
33.24 On-time 2 warn message
1: 33.23 On-time 2 source
10: 5.4 Main fan on-time counter.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an ontime timer.
Programmable warnings:
33.14 On-time 1 warn message
Cabinet fanA88E
0: 33.13 On-time 1 source
33.24 On-time 2 warn message
1: 33.23 On-time 2 source
10: 5.4 Main fan on-time counter.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an ontime timer.
Programmable warnings:
33.14 On-time 1 warn message
Cooling fanA88F
0: 33.13 On-time 1 source
33.24 On-time 2 warn message
1: 33.23 On-time 2 source
10: 5.4 Main fan on-time counter.
Check the auxiliary code. Check the
source of the warning corresponding to
the code:
Warning generated by an ontime timer.
Programmable warnings:
33.14 On-time 1 warn message
Additional
cooling fan
A890
0: 33.13 On-time 1 source
33.24 On-time 2 warn message
1: 33.23 On-time 2 source
10: 5.4 Main fan on-time counter.
Check the auxiliary code (format XYY).An analog signal is outside the limits
specified for the analog input.
AI Supervised
Warning
A8A0
“X” specifies the location of the input (0:
AI on control unit; 1: I/O extension
module 1, etc.), “YY” specifies the input
and limit (01: AI1 under minimum, 02:
574 Fault tracing