2000-OSM, F1 4-40
Temperature Configuration Table Low/High Alarm Limits
Zone Name
Temperature Control Table Zone relationship
Set Point, by entry number in method
Ramp Rate, by entry number in method
Temperature Check Table Zone relationship
Alarm Temperature value, by entry number
in method
Action (Display or Abort), by entry number
in method
Zone Controller Type Controller type
Zone Config Table Zone Configuration
Sensor Type
Heat/Air relationship
Manual Temperature Control Mode
This screen allows operator control of the Digital Temperature Controller. The Manual Temperature
Control Mode screen allows you to change these fields: Valve #, Zone #, Set Point, and Ramp Rate.
Always check the original application-specific temperature limits listed in the analyzer's Data Package
to validate any changes. To access this screen perform the following steps:
1. On the Background screen, press the F2 (Manual Control) soft key.
2. On the Manual Control Mode screen, press the F4 (Press. & Temp. Control) soft key.
3. On the Pres and Temp Control screen, cursor to TEMP CONTROL and press the F2 (Manual
Temp Control) soft key.
To Next Page
Loading...
