ABB PGC2000 User Manual

2000-OSM, F1 10-25
PUT ACTUAL RETENTION TIME Command
Description: Changes actual (measured) retention time for a particular component.
Syntax: PUT_ACTUAL_RT(method%,component%,retention_time!)
Comments method% is the method table (1-8).
component% is the component number for which the actual retention time
is to be updated.
retention_time! is the new actual retention time for specified component.
Example: 0010 PUT_ACTUAL_RT(1,2,123.64)
The measured retention time of the peak for the second component is set at
123.64 seconds into analysis method one.
PUT ASTM Command
Description: Sets the Sim Dis ASTM parameter in the Sim Dis Setup Screen (Sim Dis
analyzers only).
Syntax: PUT_ASTM(setting%)
Comments: setting% is the ASTM parameter in the Sim Dis Setup Screen, where:
0 sets the ASTM parameter to ASTM-2887
1 sets the ASTM parameter to ASTM-3710
Example: 0010 PUT_ASTM(0)
The ASTM parameter in Sim Dis Setup Screen is set to ASTM2887.
PUT BENCHMARK CONCENTRATION Command
Description: Updates the benchmark concentration for a particular component.
Syntax: PUT_BENCH_CONC(method%,component%, concentration!)
Comments: method% is the method table (1-8).
component% is the component number for which the concentration is to be updated.
concentration! is the new benchmark concentration for the specified component.
Example: 0010 PUT_BENCH_CONC(1,2,10.1234)
The concentration of 10.1234 is stored in the benchmark concentration for
component two of analysis method one.
PUT BLEND Command
Description: Sets the Sim Dis Blend Number parameter in the Stream Table (Sim Dis
analyzers only).
Syntax: PUT_BLEND(stream%,setting%)
Comments: stream% is the stream to get the blend for.
setting% is the Sim Dis Blend Number (1-25), also known as the Correlation
Factor Table.
Example: 0010 PUT_BLEND(1,25)
Sim Dis Blend Number for stream 1 in the Stream Table is set to 25.
PUT CALIBRATION CONCENTRATION Command
Description: Updates calibration concentration for a particular component.
Syntax: PUT_CAL_CONC(method%,component%,concentration!)
Comments: method% is the method table (1-8).
component% is the component number for which the calibration
concentration is to be updated.
concentration! is the new calibration concentration for the specified
component.

ABB PGC2000 Specifications

General

Brand	ABB
Model	PGC2000
Category	Laboratory Equipment
Language	English