10-22 2000-OSM, F1
Example: 0010 IF OP_MSG_ALARM THEN LPRINT
0020 :”ALARM”
PEAK AREA Function
Description: Returns the peak’s corrected area.
Syntax: PK_AREA(peak%)
Comments: peak% is the peak number (1 to N_PEAKS).
Example: 0010 FOR I = 1 TO N_PEAKS
0020 LPRINT PK_AREA(I)
0030 NEXT I
The example prints the area under each peak.
PEAK COMPONENT NUMBER Function
Description: Returns the component number whose retention time matches the crest
time for the peak.
Syntax: PK_COMP_NUM(peak%)
Comments: peak% is the peak number (1 to N_PEAKS).
Example: 0010 LPRINT COMP_NAME$(1,
0020 :PK_COMP_NUM(2))
Prints the name of the component in method one for the second peak
detected in the analysis.
PEAK CREST AMPLITUDE Function
Description: Returns the peak’s amplitude at crest.
Syntax: PK_CREST_AMP(peak%)
Comments: peak% is the peak number (1 to N_PEAKS).
Example: 0010 FOR I = 1 TO N_PEAKS
0020 LPRINT PK_CREST_AMP(I)
0030 NEXT I
Prints the amplitude of each peak’s crest.
PEAK CREST TIME Function
Description: Returns the peak’s crest time.
Syntax: PK_CREST_TIME(peak%)
Comments: peak% is the peak number (1 to N_PEAKS).
Example: 0010 FOR I = 1 TO N_PEAKS
0020 LPRINT PK_CREST_TIME(I)
0030 NEXT I
Prints the time of each peak’s crest.
PEAK END AMPLITUDE Function
Description: Returns the amplitude at the end of the peak.
Syntax: PK_END_AMP(peak%)
Comments peak% is the peak number (1 to N_PEAKS)
Example: 0010 FOR I = 1 TO N_PEAKS
0020 LPRINT PK_END_AMP(I)
0030 NEXT I
Prints the amplitude of each peak’s end.
To Next Page
Loading...
