4-73 2000-OSM, F1
NOTE
Before making changes to VistaNET screens, verify all data with your Network
Administrator to ensure proper connection and operation with VistaNET.
1. On the Background screen press the F1 (Exit to Commands) soft key.
2. On the Commands screen, cursor to TESTING/SETUP and then press the F4 (Status Display)
soft key.
3. On the Controller Status screen, press the F2 (Clear Highway Stats) soft key. This will reset all
data to zero so you will know when VistaNET data is sent and received.
4. On the Commands screen, cursor to VISTANET and then press the F2 (VistaNET Tables and
Commands) soft key.
5. On the VN Menu screen (see Figure 4-63), cursor to STARTUP and then press the F2 (Essential
Addresses) soft key.
************ VN Menu **********
TABLES
STARTUP
TESTING
Essential Access Refresh
Escape Addresses Level VNSA
Tables
F1 F2 F3 F4
Figure 4-63. VN MENU SCREEN
To Next Page
Loading...
Need help?
General
