ABB PGC2000 - GET TEMPERATURE for a TIME Command; GET TEMPERATURE of a ZONE Command; GET TEMPERATURE TABLE Command; GET TIME for a PERCENT off Command

2000-OSM, F1 10-15
Comments: percent_off! is the percent off to convert to a temperature.
time_vs_bp_table% is the Time vs. Boiling Point Table (1-8) to use for the
conversion.
Example: 0010 TEMP! = GET_TEMP(50.0,1)
Returns the temperature for 50.0 percent off.
GET TEMPERATURE FOR A TIME Command
Description: Returns a temperature for a given time using a specified Time vs. Boiling
Point Table (Sim Dis analyzers only).
Syntax: TIME_TO_TEMP(time!,time_vs_ bp_table%)
Comments: time! is the time to convert to a temperature.
time_vs_bp_table% is the Time vs. Boiling Point Table (1-8) to use for the
conversion.
Example: 0010 TEMP! = TIME_TO_TEMP(100.0,1)
Returns the temperature that occurred at 100.0 seconds.
GET TEMPERATURE OF A ZONE Command
Description: Returns the actual temperature of the specified zone.
Syntax: GET_TEMP(zone%)
Comments: zone% is the zone number (1-5).
Example: 0010 Z1! = GET_TEMP(1)
Returns the actual temperature of zone 1.
GET TEMPERATURE TABLE Command
Description: Returns the temperature column from one of the eight Time vs. Boiling Point
Tables (Sim Dis analyzers only).
Syntax: GET_TEMP_TBL(array!,table%)
Comments: array! is a previously dimensioned array that is the destination of the
Temperature Table.
table% is the table number (1-8).
Example: 0010 N = LEN_TEMP_TBL(1)
0020 DIM A!(N)
0030 GET_TEMP_TBL(A!,1)
Gets the size of the Temperature Table, dimensions an array to hold it,
copies the table into array A!.
GET TIME FOR A PERCENT OFF Command
Description: Returns a time for a given percent off using a specified Time vs. Boiling
Point Table (Sim Dis analyzers only).
Syntax: POFF_TO_TIME(percent_off!,time_vs_bp_table%)
Comments: percent_off! is the percent off to convert to a time.
time_vs_bp_table% is the Time vs. Boiling Point Table (1-8) to use for the
conversion.
Example: 0010 TIME! = POFF_TO_TIME(50.0,1)
Returns the time that 50.0 percent off occurred.
GET TIME FOR A TEMPERATURE Command
Description: Returns a time for a given temperature using a specified Time vs. Boiling
Point Table (Sim Dis analyzers only).
Syntax: TEMP_TO_TIME(temperature!,time_vs_bp_table%)