5-14 2000-OSM, F1
2. On the screen with instructions on saving the tables, press any soft key.
3. On the Commands screen, cursor to STORAGE & CONFIG. and press the F2 (Save or Restore
Tables) soft key.
4. On the Table Storage screen cursor to SAVE TABLES TO E2PROM and press the F2 (Save
Tables) soft key.
5. When “Are Your Sure? Y/N” appears on the screen, press the “Y” key.
6. Press the F1 soft key as necessary to return to the Background screen.
7. On the Single Board Computer PCB, press and release the Reset switch. This resets the
analyzer to use the data you just saved.
To Next Page
Loading...
