AGFA CR 30-X - Installing the Service Client on the Control PC

DD+DIS150
.06E
Repair and Service
Tools and auxiliary Means
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
NOTE:
It is possible to use the CR30-X service client also on the service PC.
Following functions can be accessed:
Directly after installation of the Service Client:
 Function “Explain Error Code”
After Restore of a CR30-X backup file:
 View Infocounter
 View E-Label entries
 View Service Activity Log
 View Error Statistics
Prerequisites for Installation:
 Windows XP (home or professional)
 .Net Visual J# (to be obtained via www.microsoft.com)
2.1 Installing the Service Client on the Control PC
NOTE:

A
ll steps for software upgrade / update of the digitizer are described in a document
which is part of the software on MEDNET GSO Library (readme or enclosure
document). Depending on the software version, the procedure might be different to
the steps described here.
 The software installation for the digitizer is made in 2 steps:
Step 1: De-install the previous digitizer software (if applicable) and install the
current software (incl. service client = service software) on the control PC.
Details see this section.
Step 2: Upload the software from control PC to the digitizer.
Details see section 2.2.7.
IMPORTANT:
Before starting any software de-installation activity at the control PC, switch off the
digitizer. Otherwise the digitizer driver on the control PC will automatically
be de-installed.
(1) Select "START - Log Off <current user>" to log-off the current user.
(2) When the log-in screen appears login as "crservice".
Edition 1, Revision 2 CR 30-X Chapter 3.2 / 7
03-2010 Type 5175 / 100/110 Agfa Company Confidential