DD+DIS150.06E
Repair and Service
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2 CR 30-X Chapter 3.5 / 3
03-2009 Type 5175 / 100/110 Agfa Company Confidential
LIST OF CONTENTS
1
REPLACING THE COVERS.....................................................................................................5
1.1 Replacing the Front Cover ........................................................................................................5
1.2 Replacing the Left Cover ..........................................................................................................7
1.3 Replacing the right cover ..........................................................................................................9
1.4 Replacing the Top Cover ........................................................................................................11
2 REPLACEMENTS IN CASSETTE UNIT ................................................................................13
2.1 Replacing the Antistatic Brush Cassette Unit Entry................................................................13
2.2 Replacing the Cassette Edge Sensor.....................................................................................20
2.3 Replacing the Cassette Fixation Steel Band ..........................................................................23
2.4 Replacing the Cassette Fixation Unit......................................................................................23
2.5 Replacing the Cassette Opener Unit ......................................................................................24
2.6 Replacing the Cassette Unlocking Unit ..................................................................................31
2.7 Replacing the Chip Reader.....................................................................................................34
2.8 Replacing the Drawer Unit ......................................................................................................38
2.9 Replacing the Erasure Unit.....................................................................................................38
2.10 Replacing the Transport Unit Ball Bearings............................................................................40
2.11 Replacing the Input Rollers.....................................................................................................42
2.12 Replacing the Side Plate Transport Unit (left Hand Side) ......................................................43
2.13 Replacing the IP Handling Board............................................................................................43
2.14 Replacing the Permanent Magnets ........................................................................................43
2.15 Replacing the Drawer Motor (M4)...........................................................................................47
2.16 Replacing the Fixer Stepper Motor (M1).................................................................................47
2.17 Replacing the Opener Stepper Motor (M3).............................................................................51
2.18 Replacing the Roller Stepper Motor (M5) ...............................................................................55
2.19 Replacing the Roller Clamping Stepper Motor (M6)...............................................................59
2.20 Replacing the Roller IP Sensor...............................................................................................64
2.21 Replacing the Toothed Belt Stepper Motor Roller Clamping..................................................66
2.22 Replacing the Toothed Belt Stepper Motor Drawer................................................................74
2.23 Replacing the Toothed Belt Stepper Motor Roller ..................................................................77
To Next Page
Loading...
