DD+DIS150.06E
Repair and Service
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2 CR 30-X Chapter 3.5 / 4
03-2009 Type 5175 / 100/110 Agfa Company Confidential
2.24
Replacing the Toothed Belt Stepper Motor Opener................................................................81
2.25 Replacing the User Interface Board........................................................................................84
3 REPLACEMENTS AT SCAN MODULE .................................................................................87
3.1 Replacing the Calibration Board .............................................................................................87
3.2 Replacing the Optic Module....................................................................................................87
3.3 Replacing the PMI Power Distribution Board..........................................................................87
3.4 Replacing the PMI Board ........................................................................................................89
3.5 Replacing the PMT with Light Collector..................................................................................90
3.6 Replacing the Scan Rollers.....................................................................................................90
3.7 Replacing the Slow Scan Board .............................................................................................93
3.8 Replacing the Slow Scan Unit.................................................................................................94
3.9 Replacing the ESD Brush .......................................................................................................94
4 REPLACEMENTS AT THE MOUNTING RACK .....................................................................94
4.1 Replacing the Cassette Unit open Safety Switch ...................................................................94
4.2 Replacing the Distributor Board..............................................................................................97
4.3 Replacing the Power Supply.................................................................................................100
To Next Page
