AGFA CR 30-X - Checking the Installation Site Prerequisites; Preparing the Required Tools

DD+DIS150
.06E
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
2.1 Checking the Installation Site Prerequisites
(1) Confirm that all prerequisites described in the "Installation readiness checklist"
are fulfilled.
This checklist is available at the end of CR 30-X Service Documentation
Chapter 11, Installation Planning.
2.2 Preparing the required Tools
Following tools are required during the installation procedure:
REQUIRED TOOLS:
3 mm
cutte
r
USB Stick
(checked to be virus free)
*The last digit in the spare part number indicates the spare part revision at release of this document.
When ordering, the actual revision of the spare part is delivered.
Edition 1, Revision 5 CR 30-X Chapter 1 / 5
11-2009 Type 5175 / 100/110 Agfa Company Confidential