AGFA CR 30-X - Replacing the Cassette Edge Sensor

DD+DIS150.06E
Repair and Service
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2 CR 30-X Chapter 3.5 / 20
03-2009 Type 5175 / 100/110 Agfa Company Confidential
2.2 Replacing the Cassette Edge Sensor
REQUIRED SPARE PART*:
CM+9 5175 9060 0
* The last digit in the spare part number indicates the spare
part revision at release of this document. When ordering,
the actual revision of the spare part is delivered.
Figure 42
REQUIRED TOOLS:
3 mm
1,5 mm
REQUIRED TIME:
30 min.
DISASSEMBLY:
(1) Switch off the digitizer.
(2) Disconnect the mains cable.
(3) Simultaneously press the two buttons (A)
positioned underneath the feed table.
(4) Pull out cassette unit (B).
A
A
B
Figure 43
(5) Remove 3 upper screws.
Figure 44