AGFA CR 30-X - Service Client Menu SW-Versioning

DD+DIS150
.06E
Repair and Service
Tools and auxiliary Means
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
2.2.3 Service Client Menu “SW-Versioning”
Purpose
The “software versioning” menu allows checking if the software version currently
installed on the control PC corresponds to the version installed on the Digitizer.
Usage
(1) Select "General Device Info - SW Versioning".
(2) Select "Get installed version".
5175_chapter32_001.cdr
Get installed version
CRE_1509/1096
CRE_1509/1096
CRE_1509
CRE_1509
ok
ok
ok
Node
PMI Board/FPGA
HDL Board
SSC Board
Installed Version
Version on PC Status
Digitizer
NX Workstation
(Control PC)
CRE_1509
CRE_1509
Figure 10
IMPORTANT:
The installed versions on the PMI board, IP Handling board (HDL Board) and Slow
Scan Board (SSC Board) have always to be the same.
Edition 1, Revision 2 CR 30-X Chapter 3.2 / 14
03-2010 Type 5175 / 100/110 Agfa Company Confidential