AGFA CR 30-X - Additional, Minor Bug Fixes

DD+DIS150
.06E
Repair and Service
Software Releases and Patches
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4 CR 30-X Chapter 3.8 / 16
01-2011 Type 5175/100/105/110/120/125 Agfa Company Confidential
8.2.4 Additional, minor Bug Fixes
Following a list of minor software bugs that appeared at internal tests and are solved
with CRE_1509:
Solved Service Function related Software Bugs:
 In some cases, when working with the Service Client, the error viewer was not
visible, if an error occurred (e.g. in diagnose cycle). To solve the problem in the
worst case a reset of the control PC was required. In SW ≥ 1509 always the error
viewer is visible if an error occurs while working with the service client.
 Total number of cycles of the product was not written to the E-label and the
infocounter.
 Warnings were not stored in infocounter “error history”.
 Stall Calibration details were not logged in Service Activity Log file
 After software installation the message “SW upload required appeared.
 It was not possible to perform the stall calibration remotely.
 In some cases the service client could not re-establish communication after
software upload. It was required to reboot the control PC.
 Retries during IP handling are not logged in the infocounter.
 Software upload gave (false) error 15399.
 Error messages were not displayed when performing a diagnose cycle.
Solved Error Handling Software Bugs:
 In case of a Photomultiplier defect the digitizer software crashed: No error was
displayed.
 If the digitizer had problems writing to the cassette chip, not only NX message
“119: The file could not be saved” appeared, but also a false error message
“Problem during scan: The image may not have the required quality”.
 If FireWire communication was interrupted during scan, communication could only
be re-established by a reset of both, digitizer and control PC.
 During boot-up the stepper motors did not retry to go to home position if a problem
occurred. Now three retries are performed.
 An aging photomultiplier could not be detected.
 Retry sequence of cassette opener did not work, if cassette cover was
mechanically blocked.
 Some timeouts during scan were not transferred to the control PC, e.g. if “scan
command” did not return a response.