AGFA CR 30-X - Table of Contents

DD+DIS150
.06E
Repair and Service
Tools and auxiliary Means
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2 CR 30-X Chapter 3.2 / 3
03-2010 Type 5175 / 100/110 Agfa Company Confidential
LIST OF CONTENTS
1
MACHINE SPECIFIC TOOLS ..................................................................................................4
1.1 Required Tools..........................................................................................................................4
1.2 Recommended Tools................................................................................................................5
2 DIGITIZER SERVICE CLIENT .................................................................................................6
2.1 Installing the Service Client on the Control PC.........................................................................7
2.1.1 Troubleshooting Software Installation Problems at the Control PC..........................................9
2.2 Service Client Menus ..............................................................................................................11
2.2.1 Service Client Menu “Info Counter” ........................................................................................12
2.2.2 Service Client Menu “E-Label”................................................................................................13
2.2.3 Service Client Menu “SW-Versioning” ....................................................................................14
2.2.4 Service Client Menu “Service Activity Log”.............................................................................15
2.2.5 Service Client Menu “Error Statistics”.....................................................................................16
2.2.6 Service Client Menu “HOT Report” (Hand-over Test Report).................................................17
2.2.7 Service Client Menu “SW Upload” ..........................................................................................18
2.2.8 Service Client Menu “Diagnose Cycle” ...................................................................................20
2.2.9 Service Client Menu “Explain Error Code”..............................................................................21
2.2.10 Service Client Menu “Endurance Run Cycle” .........................................................................22
2.2.11 Service Client Menu “Selftest of Device” ................................................................................23
2.2.12 Service Client Menu “Calibration” ...........................................................................................24
2.2.13 Service Client Menu “Stall Calibration”...................................................................................25
2.2.14 Service Client Menu “Site specific Data” ................................................................................26
2.2.15 Service Client Menu “Device specific Data”............................................................................27
2.2.16 Service Client Menu “Exchanged Components”.....................................................................28
2.2.17 Service Client Menu “Maintenance Indicator”.........................................................................31
2.2.18 Service Client Menu “Backup & Restore” ...............................................................................32
3 REMOTE DESKTOP ..............................................................................................................34